:Face Detect

Revision as of 17:21, 12 March 2018 by JP (talk | contribs) (Installation Requirements)

Face Detect

Description

Face detection is to detect if there is any human face appearing in the video, and capture the face then send it to the NVR for analysis and processing, it can activate snapshot, record and alarm.

FaceDetect.png

Installation Requirements

Face Detect Install Requirements.png

The horizontal distance between camera and monitoring target is d(m), the camera installation height is h(m), depression angle of camera is α(degree) (it is the included angle between the camera monitoring direction and horizontal surface). You can refer to the following parameter table:

Parameter Recommended value Range
Height h(m) 2.5 2~3
Horizontal distance d(m) 6 4~20
α(degree) ≤15 10~15

If the actual situation fails to meet the settings recommended in the table above, you can refer to the table below. Select the most suitable parameter configuration if it can guarantee that the face pixel is more than 150 x 150 (it can reach 200 x 200 ideally) in 1080P.

Height(m) Horizontal distance(m)
2 4~20
2.25 5~20
2.5 6~20
2.75 7~20
3 8~20

Internet Explorer Setup

Prerequisites

  • Intelligent Network Camera.
  • Updated firmware that supports intelligent features.
  • Internet Explorer.

IVS Best Practices

To assess issues with IVS compatibility between the camera and NVR, please update both devices to the most current firmware and factory reset the NVR, and use the hard reset button to reset the camera.

Video Instructions

Step by Step Instructions

1. Click “Enable”.

Face Detect1.png

2. Click face enhancement to enhance the face image display.

Face Detect2.png

3. Select max and min size, draw max and min target for target filtering. This step is to filter target, which can’t be operated under default status.

Face Detect3.png

4. Activate record, alarm, email and snapshot according to the requirements.

Face Detect4.png

5. Target filter can set max target and min target, which means it can detect max and min target.

Face Detect5.png

6. Click ok to complete settings.

Face Detect6.png

System Interface Setup

Prerequisites

Video Instructions

Step by Step Instructions

1. Go to Event.

IntrusionSetupSystem1.png

2. Enable Face detect under IVS and then hit apply and save.

FaceDetectionSetupSystem2.png

SmartPSS Setup

Prerequisites

  • SmartPSS 2.0
  • IVS capable device with Face Detection
  • Upgraded devices to latest firmware

Smart PSS Video Instructions

Step by Step Instructions

1. Launch and Log into Smart PSS

600px

2. Select "Live".

600px

3. From Live View Select Device that is IVS capable -> right click on device and select IVS Config.

600px

4. Select Face detection -> Select Next.

600px

5.Draw a Detection Zone

600px

6. Select Config for arming schedule and choose what days Face Detect is to be enabled.

600px

7. Select Alarm -> Choose alarm type such as Record -> Select Save

600px

8.Select Target Filter -> Select Enable -> Choose either "Width and Height or Width and Height" -> Select Draw to size the target filter (Inner green box size is minimum target, Outer green box is the maximum target) -> Apply and Save.

600px