Difference between revisions of "Troubleshoot/NVR/Troubleshoot Date and Time"
| Line 6: | Line 6: | ||
*Crystal is broken. | *Crystal is broken. | ||
| + | 1. Make sure the "Time Zone" is set correctly. | ||
| + | |||
| + | [[file:DateandTimeTroubleshoot1.png]] | ||
| + | 2. Setup DST, if applicable. | ||
| + | |||
| + | *Daylight Savings Time begins the 2nd week of March | ||
| + | *Daylight Savings Time ends the 1st week of November. | ||
| + | [[file:DateandTimeTroubleshoot2.png]] | ||
| + | |||
| + | 3. "Sync PC" if all else fails. | ||
| + | [[file:DateandTimeTroubleshoot3.png]] | ||
| + | |||
| + | 4. Click, "OK" to save your changes. | ||
| + | [[file:DateandTimeTroubleshoot4.png]] | ||
[[Category:Record_Setup]] | [[Category:Record_Setup]] | ||
Revision as of 16:45, 15 March 2016
How to set the date and time
Time display is not correct.
There are following possibilities:
- Setup is not correct
- Battery contact is not correct or voltage is too low.
- Crystal is broken.
1. Make sure the "Time Zone" is set correctly.
2. Setup DST, if applicable.
- Daylight Savings Time begins the 2nd week of March
- Daylight Savings Time ends the 1st week of November.
3. "Sync PC" if all else fails.
4. Click, "OK" to save your changes.
