Revision as of 21:23, 23 April 2019

Control4 Integration Features

Allows NVR Icon on Watch Menu, and Connection paths for HDMI and VGA into a Control4 video system
Event Connection for Triggers FROM NVR (using either, connection binding or Composer Event)
NUMBER buttons select that channel (example: Button 6 = Camera 6 on the TV)
Setup RED, GREEN, YELLOW, and BLUE buttons to trigger different views on TV
Uses Control4’s cable Proxy
Connection paths for camera proxy interface

Driver Version-Current Driver version install on project
Driver Persistence-Current saved state of driver data. (note: if this says, ‘Not Saved’ and director reboots, the data will not be available on Load of driver).
Driver Information-Driver Specific information
Debug Mode (Default: Off)-Used to view the driver log. Debug will turn off automatically after 15 minutes
Device Connection-Current Device State (Online or Offline, Failed to Check in)
Polling Timer (Seconds)-Amount of time between polling checks. If 0 then polling is disabled.
NVR IP Address
IP address of NVR
NVR Username-Username used to log into NVR
NVR Password-Password used to log into NVR
# of Channels-The quantity of channels on NVR, example: 4, 8, 16, 256
NVR Model-Will display the Model number of the NVR attached to the driver
Remote RED Button-Shortcut for RED Room Command (default: 4 Split Group 0)
Remote GREEN Button-Shortcut for GREEN Room Command (default: 4 Split Group 1)
Remote YELLOW Button-Shortcut for YELLOW Room Command (default: 8 Split)
Remote BLUE Button-Shortcut for BLUE Room Command (default: 9 Split)
Server Communication Port-The port used for Event Notification (default: unused port chosen during initial setup automatically)

@@ Line 27: / Line 27: @@
 ==Security Icon Visible on Watch Menu==
+[[file:Control4_ExampleImage4.JPG|600px]]
 ==NVR Remote Control==