Difference between revisions of "3rd Party VMS/Control4/Setup Video Feeds"
(Created page with "=How to Setup Video Feeds on Dahua IP Camera or Recorder=") |
(→How to Setup Video Feeds on Dahua IP Camera or Recorder) |
||
| Line 1: | Line 1: | ||
=How to Setup Video Feeds on Dahua IP Camera or Recorder= | =How to Setup Video Feeds on Dahua IP Camera or Recorder= | ||
| + | ==Description== | ||
| + | ==Prerequisites== | ||
| + | ==Video Instructions== | ||
| + | <embedvideo service="youtube">https://www.youtube.com/watch?v=EXAMPLE</embedvideo> | ||
| + | ==Step by Step Instructions== | ||
| + | Note: Certain older Control4 equipment require MJPEG for video stream (HC800, HC250, Infinity Touchscreens etc..). If these older devices are used at property, the dealer MUST enable Sub Stream and set to MJPEG. If dealer is using T3 and EA controllers, MJPEG does not need to be used | ||
| + | |||
| + | *Log into NVR or use GUI and go to Setup | ||
| + | *Select IMAGE, ENCODE | ||
| + | *Choose Proper Channel (repeat for each channel) | ||
| + | *Change Main Stream Settings to the following (note: these settings are best practices; individual systems may require modification of these settings for certain applications) | ||
| + | |||
| + | 1. Code-Stream Type: Continuous | ||
| + | |||
| + | 2. Compression: H.264 | ||
| + | |||
| + | 3. Resolution: 1280*720(720P) | ||
| + | |||
| + | 4. Frame Rate(FPS): 13 | ||
| + | |||
| + | 5. Bit Rate Type: VBR | ||
| + | |||
| + | 6. Bit Rate: 1024 | ||
| + | |||
| + | IF MJPEG is required do the following: | ||
| + | |||
| + | 1. Enable Sub Stream on Channel | ||
| + | |||
| + | 2. Compression: MJPEG | ||
| + | |||
| + | 3. Resolution: 704*480(D1) | ||
| + | |||
| + | 4. Frame Rate(FPS): 13 | ||
| + | |||
| + | 5. Bit Rate: 1024 | ||
Revision as of 21:29, 23 April 2019
Contents
How to Setup Video Feeds on Dahua IP Camera or Recorder
Description
Prerequisites
Video Instructions
Step by Step Instructions
Note: Certain older Control4 equipment require MJPEG for video stream (HC800, HC250, Infinity Touchscreens etc..). If these older devices are used at property, the dealer MUST enable Sub Stream and set to MJPEG. If dealer is using T3 and EA controllers, MJPEG does not need to be used
- Log into NVR or use GUI and go to Setup
- Select IMAGE, ENCODE
- Choose Proper Channel (repeat for each channel)
- Change Main Stream Settings to the following (note: these settings are best practices; individual systems may require modification of these settings for certain applications)
1. Code-Stream Type: Continuous
2. Compression: H.264
3. Resolution: 1280*720(720P)
4. Frame Rate(FPS): 13
5. Bit Rate Type: VBR
6. Bit Rate: 1024
IF MJPEG is required do the following:
1. Enable Sub Stream on Channel
2. Compression: MJPEG
3. Resolution: 704*480(D1)
4. Frame Rate(FPS): 13
5. Bit Rate: 1024
