Difference between revisions of "EventVideoDetect"

Parameter

Function

Enable

You need to check the box to enable motion detection function.

Enable video mask detection

You need to check the box to enable video mask detection alarm.

Enable defocus detection

You need to check the box to enable defocus detection alarm.

Working Period

Here you can set arm/disarm period. Click on set button to open period setup menu. 

There are six periods every day for setup and you must check box in front of each period to enable it.

Note: Period setup can be done by dragging mouse while not release left mouse.

Anti-dither

System only memorizes one event during the anti-dither period. The value ranges from 0s to 100s.

Area

Here you can set motion detection region and its sensitivity and area. (The higher the sensitivity is, the easier to trigger motion detect; the smaller the area, the easier to trigger motion detect.) The default covers all regions. You must click on save before enabling your setup.

Record

Check it and so when alarm occurs, system will auto record. You shall set record period in Storage>Schedule and select auto record in record control interface.

Record Delay

System can delay the record for specified time after alarm ended. The value ranges from 10s to 300s.

Relay out

Enable alarm activation function. You need to select alarm output port so that system can activate corresponding alarm device when alarm occurs. 

Alarm Delay

System can delay the alarm output for specified time after alarm ended. The value ranges from 10s to 300s.

Send Email

If you enabled this function, System can send out email to alert you when

alarm occurs and ends. User can set email address in Network>SMTP.

Audio linkage

Check it and the system will play alarm audio file when alarm occurs. Users can set the recorded or uploaded audio file in “camera setting ＞ audio ＞ alarm audio”.

Flash linkage

Check it and the flash will be on when alarm occurs, and the flash will

 be off until the end of alarm after corresponding delay.   

PTZ

• Here you can set PTZ movement when alarm occurs. Such as go to preset x when there is an alarm.
• The event type includes: preset, tour and pattern.

Snapshot

You need to check the box here so that system can backup motion detection snapshot file. You shall set snapshot period in Storage>Schedule.

Parameter

Function

Name

Default area name includes Region1, Region2, Region3, Region4 and custom.

Sensitivity

It is sensitivity of brightness as motion detection is more possible to be trigger with higher sensitivity. You can set up different sensitivities. The range is 0~100. The recommenced value is 30~70.

Area threshold

It is to check the relationship between object and its area. The lower the area threshold, the easier to trigger motion detection. You can set up different threshold for each area. The range is 0~100. The recommenced value is 0~10.

Waveform

Red means motion detect is triggered. Green means motion detect is not triggered.

Delete all

Clear all the detection areas with color.

Delete

Delete selected area.