Notice: Firmware Links Under Maintenance We are currently undergoing maintenance on all firmware links. If any links are inaccessible, please email or contact Tech Support for the firmware. We appreciate your patience during the maintenance, thank you for your understanding.
Difference between revisions of "Troubleshoot/NVR/No HDD"
(→Solutions) |
(→System can not detect hard disk.) |
||
| Line 7: | Line 7: | ||
* Main board SATA port is broken. | * Main board SATA port is broken. | ||
* HDD is not compatible. | * HDD is not compatible. | ||
| + | * Insufficient power. | ||
===Solutions=== | ===Solutions=== | ||
Revision as of 20:13, 21 March 2016
System can not detect hard disk.
There are following possibilities:
- HDD is broken.
- HDD ribbon is damaged.
- HDD cable connection is loose.
- Main board SATA port is broken.
- HDD is not compatible.
- Insufficient power.
Solutions
- Reboot Recorder.
- Disconnect the hard drive from the device, then boot it up with the HDD disconnected. If there are no errors when booting without a hard drive, then the hard drive is most likely the problem and needs to be replaced.
- Format HDD.
- Check HDD compatibility.
- Check HDD cables and if connections are secure.
- If SATA port is broken try another SATA port.
- Reset to device to factory settings.
- Make sure you have the correct power cable for the Device.
- Replace HDD.
