Troubleshoot/NVR/Troubleshoot Date and Time

Revision as of 16:45, 15 March 2016 by JP (talk | contribs)

How to set the date and time

Time display is not correct.

There are following possibilities:

  • Setup is not correct
  • Battery contact is not correct or voltage is too low.
  • Crystal is broken.

1. Make sure the "Time Zone" is set correctly.

DateandTimeTroubleshoot1.png 2. Setup DST, if applicable.

  • Daylight Savings Time begins the 2nd week of March
  • Daylight Savings Time ends the 1st week of November.

DateandTimeTroubleshoot2.png

3. "Sync PC" if all else fails. DateandTimeTroubleshoot3.png

4. Click, "OK" to save your changes. DateandTimeTroubleshoot4.png