IPPTZ/Pelco and RS485

Revision as of 14:44, 29 April 2019 by JP (talk | contribs) (Self-diagnosis System Information)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

Pelco and RS485

Self-diagnosis System Information

PTZ Self Diagnosis system info.png

After installation, please connect speed dome to power. The system goes on a self-diagnosis, and then it pops up the above interface to show the system information. The above interface disappears after speed dome received the first command (or the display time lasts for 4 minutes.)

  • ADDR: Here you can view dome address information. For example, 001-H, -H is the hardware

address number, -S is software address mode.

  • BR: Dome communication baud rate.
  • PARITY: Communication parity bit format.
  • VERSION: Dome software version.

IP PTZs

Disclaimer: Depending on your PTZ model, these features might not work.

  • Call preset 28 or preset 95 to go to dome menu
  • Call preset 29 or preset 99 to go to scan.
  • Call preset 24 or preset 81 to go to pattern.
  • Call preset 25 or preset 82 to go to tour.
  • Call preset 30 or preset 96 to stop scan or pattern.
  • Call preset 31 or preset 83 to begin rotation.
  • Call preset 33 to enable PTZ 180 degrees rotation.
  • Call preset 34 to set dome position as 0.
  • Set preset 26 or 92 to set scan left limit
  • Set preset 27 or 93 to set scan right limit.
  • Set preset 22 or 79 to begin record.
  • Set preset 23 or 80 to stop record.

HD-CVI PTZs

Please note the IR speed dome can automatically recognize the industrial standard protocol, PELCO-D. PELCO-P. Usually you do not need to set the protocol.