Doorbell/DB11/Modify PIR Detection Zone

Revision as of 21:52, 8 April 2024 by AlexS (talk | contribs)

Modify DB11 PIR Motion Detection Zone

Description

How to adjust the PIR and Motion Detection settings on a DB11

Prerequisites

Step by Step Instructions

1. Open the DMSS app and select Device at the bottom.
Then tap on the 3 dots "..." to the right of the DB11

DB11ModifyPassword1.png

2. Tap on Device Details

DB11ModifyPassword2.png

3. Tap on Arming Settings

DB11PIRMotionSetup1.png

4. Enable the slider next to Motion Detection.
Then tap on PIR Region

DB11PIRMotionSetup2.png

5. Drag the slider on the right for the amount of distance you want the PIR to monitor. (100% = 5m [16.50 ft])
Tap the 3 zones either ON or OFF.
Select Save at the top

LincX2ProPIRFloodlight11.png

6. Tap on Motion Detection Area

DB11PIRMotionSetup3.png

7. Adjust the areas that the camera will look for motion by keeping areas in red highlighted for motion detection or clear to not detect for motion.
Tap on the broom icon on the left to clear everything highlighted on the screen.
Tap on the center icon to swap between areas that are highlighted and not highlighted.
Tap on the eraser icon on the right to switch between adding or removing highlighted areas.
When you are done, tap on the floppy disk save icon at the top right.
Then tap on the back arrow at the top left

LincX2ProMotionDetection8.png