NVR/Basic Setup/Initial Setup

Revision as of 18:17, 1 August 2019 by Arran Williams (talk | contribs)

Boot up and Shutdown

Boot up

Before the boot up, please make sure:

  • For device security, please connect the NVR to the power adapter first and then connect the device to the power socket.
  • The rated input voltage matches the device power on-off button. Please make sure the power wire connection is OK. Then click the power on-off button.
  • Always use the stable current, if necessary UPS is a best alternative measure.

Please follow the steps listed below to boot up the device. 1. Connect the device to the monitor and then connect a mouse. 2. Connect power cable. 3. Click the power button at the front or rear panel and then boot up the device. After device booted up, the system is in multiple-channel display mode by default.

Startup Wizard

After device successfully booted up, it goes to startup wizard. Click Cancel/Next button, you can see system goes to login interface. NVRStartupWizard.png

Click Smart add, Cancel button or Next button, system goes to login interface.

System consists of four accounts:

  • Username: admin. Password: admin. (administrator, local and network)
  • Username: 888888. Password: 888888. (administrator, local only)
  • Username: 666666. Password: 666666(Lower authority user who can only monitor, playback, backup and etc.)
  • Username: default. Password: default (hidden user). Hidden user “default” is for system interior use only and can not be deleted. When there is no login user, hidden user “default” automatically login. You can set some rights such as monitor for this user so that you can view some channel view without login.

Note: For security reason, please modify password after you first login. Within 30 minutes, three times login failure will result in system alarm and five times login failure will result in account lock!

NVRStartupWizard2.png

Click Next button, you can go to network interface.

NVRStartupWizard3.png

Click Next button, you can go to remote device interface.

NVRStartupWizard4.png

Click Next button, you can go to Schedule interface.

NVRStartupWizard5.png

Click Finish button, system pops up a dialogue box. Click the OK button, the startup wizard is complete.

NVRStartupWizard6.png

Shutdown

  • When you see corresponding dialogue box “System is shutting down…” Do not click power on-off button directly.
  • Do not unplug the power cable or click power on-off button to shutdown device directly when device is running (especially when it is recording.)


There are three ways for you to log out.

  1. Main menu (RECOMMENDED)

From Main Menu->Shutdown, select shutdown from dropdown list.

Click OK button, you can see device shuts down.

NVRIShutdown.png

  1. From power on-off button on the front panel or remote control

Press the power on-off button on the NVR front panel or remote control for more than 3 seconds to shutdown the device.