Video Intercom/SIP 2.0/Single VTH and VTO Onekey Config Setup

Revision as of 23:41, 14 January 2021 by William.V (talk | contribs)

Single VTH and VTO One key Config Setup

Description

This article will go over the One-Key Config setup on our VTH2421F-P. As of writing this article, the VTH2421F-P is the only model that support this feature.

The VTH does not have a Web interface so the whole setup will be done on the local Interface.

Pre-requisites

Video Instructions

Step by Step Instructions

1. Boot up both The VTH and VTO. The initial page will ask you to change the Region and Language. Click on the Region

Single VTH and VTO One key Config Setup V2-1.png

2. Locate and select your region. Then click on OK

Single VTH and VTO One key Config Setup V2-2.png

3. English will be selected by default so click on OK.

Single VTH and VTO One key Config Setup V2-3.png

4. Select Villa then OK

Single VTH and VTO One key Config Setup V2-4.png

5. Select First-time Config then click on OK

Single VTH and VTO One key Config Setup V2-5.png

6. The VTH will automatically be set to DHCP and will grab an IP address from the router.:

Note: If you are assigning a static IP select Static IP and enter a valid IP Address

Single VTH and VTO One key Config Setup V2-6.png

7. Enter a password and an email for the VTH then click on Next.

Single VTH and VTO One key Config Setup V2-7.png

8. Enter a Password and an email for the VTO then click on next.:

Note:VTO will require a 8 character password (Alphabetical and Numerical Combination)

Single VTH and VTO One key Config Setup V2-8.png

9. Click on the Initialize buttons to finish the initialization process. This will take a few seconds.

Single VTH and VTO One key Config Setup V2-9.png

10. Click on Next when the initialize buttons grey out.

Single VTH and VTO One key Config Setup V2-10.png

11. The VTH is now fully setup. The VTO will grab a DHCP address but we still need to edit the settings.

Single VTH and VTO One key Config Setup V2-11.png

12. Here you can assign it a Static IP address or leave it on the acquired IP. Video Standard will be on PAL by default so select NTSC. Manually enter the time and date. Click on OK when completed

Single VTH and VTO One key Config Setup V2-12.png

13. Click on One-key Config to finalize the setup.

Single VTH and VTO One key Config Setup V2-13.png

14. The VTO will reboot and the percentage will stay at 66% until it fully boots back up.

Single VTH and VTO One key Config Setup V2-14.png

15. IMPORTANT: Let the VTO finalize any last configuration for at least ONE MINUTE before initiating a call

Single VTH and VTO One key Config Setup V2-15.png