Video Intercom/Standalone VTO and DSS Express Setup

Revision as of 22:32, 27 January 2021 by William.V (talk | contribs)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

Standalone VTO and DSS Express Setup

Description

This article will go over the Video Intercom setup with DSS Express acting as the SIP Sever. DSS Express will receive the notification when the VTO initiates the call

Prerequisites

  • DSS Express
  • VTO with SIP 2.0 Firmware

Devices

NOTE: These are the device settings we used for this article
Icon Device Network Settings SIP Server Settings ID No.
DSSExpressLogo.png DSS Express 192.168.1.200

Sip Server Username:system
Sip Server Password:admin123
Status:Enabled

Not Needed
VTO2202F.png VTO2202F-P 192.168.1.230

Server IP:192.168.1.200
Server Type:ExpressDSS
Network Port:5080
Username:8001
Register Password:Leave Default
Domain:VDP
Sip Server Username:system
Sip Server Password:admin123
Status:Disabled

8001 (VTO No)

Video Instructions

Step by Step Instructions

1.Login to the Video Intercom Web Interface to start the initialization

Standalone VTO and DSS Express Setup-1.png

2. Setup a new password for the VTO and click on NEXT

Standalone VTO and DSS Express Setup-2.png

3. Enter an email for future password reset

Standalone VTO and DSS Express Setup-3.png

4. Login to the VTO

Standalone VTO and DSS Express Setup-4.png

5. Go to the Network settings

Standalone VTO and DSS Express Setup-5.png

6. Navigate over to the SIP Server settings and disable it

Standalone VTO and DSS Express Setup-6.png

7. You can now enter the login credentials of the DSS Express. In this article we used the credentials listed on the "devices" chart above. Once the information is entered click on SAVE and the VTO will reboot

Status:Disabled
Server IP:(IP Address of DSS Express Server)
Server Type:ExpressDSS
Network Port:5080
Username:8001
Register Password:(Leave Default)
Domain:VDP
Sip Server Username:system
Sip Server Password:(DSS Express Server Password)

Standalone VTO and DSS Express Setup-7.png

8. After the reboot, go to Local Settings and enable the Calling Center Period. We are now done setting up the VTO

Standalone VTO and DSS Express Setup-7.5.png

9. Login to the DSS Client and go to Devices

Standalone VTO and DSS Express Setup-8.png

10. Click on Add and enter the VTO's login information. Be sure to select the Device Category as Video Intercom and click on Add to complete the addition

Standalone VTO and DSS Express Setup-9.png

11. To remove the Building error open a new tab

Standalone VTO and DSS Express Setup-10.png

12. Go to Config

Standalone VTO and DSS Express Setup-11.png

13. Highlight the server on the left and go to Residence Config

Standalone VTO and DSS Express Setup-12.png

14. Disable the Building option and confirm by clicking OK

Standalone VTO and DSS Express Setup-13.png

15. The VTO will now go online and ready to call DSS Express

Standalone VTO and DSS Express Setup-14.png

16. Here is an example of an incoming call

Standalone VTO and DSS Express Setup-15.png