Difference between revisions of "Troubleshoot/NVR/No HDD"
| (23 intermediate revisions by 3 users not shown) | |||
| Line 1: | Line 1: | ||
| − | + | ==System can not detect hard disk.== | |
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | [[file:HDD.jpg]] | + | ====There are following possibilities:==== |
| + | |||
| + | * HDD is broken. | ||
| + | * HDD ribbon is damaged. | ||
| + | * HDD cable connection is loose. | ||
| + | * Main board SATA port is broken. | ||
| + | * HDD is not compatible. | ||
| + | * Insufficient power. | ||
| + | |||
| + | ====Solutions==== | ||
| + | * Reboot Device. | ||
| + | * Disconnect the hard drive from the device, then boot it up with the HDD disconnected. If there are no errors when booting without a hard drive, then the hard drive is most likely the problem and needs to be replaced. | ||
| + | * Format HDD. | ||
| + | * If you cannot format HDD from device, format HDD from a PC. | ||
| + | * Check HDD compatibility. | ||
| + | * Check HDD cables and if connections are secure. | ||
| + | * If SATA port is broken try another SATA port. | ||
| + | * Reset to device to factory settings. | ||
| + | * Make sure you have the correct power cable for the Device. | ||
| + | * Replace HDD. | ||
| + | * Open Casing and check jumper settings | ||
| + | |||
| + | |||
| + | SATA Cable | ||
| + | |||
| + | [[file:harddrive1.jpg|500px]] | ||
| + | |||
| + | SATA into Harddrive | ||
| + | |||
| + | [[file:harddrive2.jpg|500px]] | ||
| + | |||
| + | SATA from motherboard to Harddrive | ||
| + | |||
| + | [[file:harddrive3.jpg|500px]] | ||
| + | |||
| + | [[File:HDD.jpg|right|alt=HDD|link=https://en.wikipedia.org/wiki/Hard_disk_drive]] | ||
| + | [[Category:Troubleshoot]] | ||
| + | [[Category:HDD]] | ||
Latest revision as of 19:04, 17 August 2016
System can not detect hard disk.
There are following possibilities:
- HDD is broken.
- HDD ribbon is damaged.
- HDD cable connection is loose.
- Main board SATA port is broken.
- HDD is not compatible.
- Insufficient power.
Solutions
- Reboot Device.
- Disconnect the hard drive from the device, then boot it up with the HDD disconnected. If there are no errors when booting without a hard drive, then the hard drive is most likely the problem and needs to be replaced.
- Format HDD.
- If you cannot format HDD from device, format HDD from a PC.
- Check HDD compatibility.
- Check HDD cables and if connections are secure.
- If SATA port is broken try another SATA port.
- Reset to device to factory settings.
- Make sure you have the correct power cable for the Device.
- Replace HDD.
- Open Casing and check jumper settings
SATA Cable
SATA into Harddrive
SATA from motherboard to Harddrive
