Difference between revisions of "VideoLossCam"
(Created page with "===After I connected to the IP channel, there one*window output is OK, but there is no multiple*window output.=== There are following possibilities: *Check the sub stream of t...") |
(→After I connected to the IP channel, there one*window output is OK, but there is no multiple*window output.) |
||
| (4 intermediate revisions by 2 users not shown) | |||
| Line 1: | Line 1: | ||
===After I connected to the IP channel, there one*window output is OK, but there is no multiple*window output.=== | ===After I connected to the IP channel, there one*window output is OK, but there is no multiple*window output.=== | ||
There are following possibilities: | There are following possibilities: | ||
| − | *Check the sub stream of the camera has been enabled or not. | + | |
| − | *Check the sub stream type of the camera is H.264 or not. | + | * Lower, FPS, Bitrate, change CBR to VBR and set to sub-stream on some of the cameras. |
| − | *Check the device supports camera sub stream resolution or not (such as 960H, D1, | + | * Check the sub stream of the camera has been enabled or not. |
| + | * Check the sub stream type of the camera is H.264 or not. | ||
| + | * Check the device supports camera sub stream resolution or not (such as 960H, D1,CIF,etc.) | ||
| + | |||
| + | [[File:sub_stream_web_enable.jpg|left]] | ||
| + | |||
| + | [[Category:Troubleshoot]] | ||
| + | [[Category:Camera Troubleshoot]] | ||
Latest revision as of 21:29, 1 September 2016
After I connected to the IP channel, there one*window output is OK, but there is no multiple*window output.
There are following possibilities:
- Lower, FPS, Bitrate, change CBR to VBR and set to sub-stream on some of the cameras.
- Check the sub stream of the camera has been enabled or not.
- Check the sub stream type of the camera is H.264 or not.
- Check the device supports camera sub stream resolution or not (such as 960H, D1,CIF,etc.)
Error creating thumbnail: Unable to save thumbnail to destination
