Difference between revisions of "IPPTZ/Pelco and RS485"
(→HD-CVI PTZs) |
(→Self-diagnosis System Information) |
||
| (One intermediate revision by the same user not shown) | |||
| Line 1: | Line 1: | ||
=Pelco and RS485= | =Pelco and RS485= | ||
| + | ==Self-diagnosis System Information== | ||
| + | [[File:PTZ_Self_Diagnosis_system_info.png]] | ||
| + | |||
| + | After installation, please connect speed dome to power. The system goes on a self-diagnosis, and then it pops up the above interface to show the system information. The above interface disappears after speed dome received the first command (or the display time lasts | ||
| + | for 4 minutes.) | ||
| + | |||
| + | *ADDR: Here you can view dome address information. For example, 001-H, -H is the hardware | ||
| + | address number, -S is software address mode. | ||
| + | *BR: Dome communication baud rate. | ||
| + | *PARITY: Communication parity bit format. | ||
| + | *VERSION: Dome software version. | ||
| + | |||
==IP PTZs== | ==IP PTZs== | ||
Disclaimer: Depending on your PTZ model, these features might not work. | Disclaimer: Depending on your PTZ model, these features might not work. | ||
Latest revision as of 14:44, 29 April 2019
Pelco and RS485
Self-diagnosis System Information
After installation, please connect speed dome to power. The system goes on a self-diagnosis, and then it pops up the above interface to show the system information. The above interface disappears after speed dome received the first command (or the display time lasts for 4 minutes.)
- ADDR: Here you can view dome address information. For example, 001-H, -H is the hardware
address number, -S is software address mode.
- BR: Dome communication baud rate.
- PARITY: Communication parity bit format.
- VERSION: Dome software version.
IP PTZs
Disclaimer: Depending on your PTZ model, these features might not work.
- Call preset 28 or preset 95 to go to dome menu
- Call preset 29 or preset 99 to go to scan.
- Call preset 24 or preset 81 to go to pattern.
- Call preset 25 or preset 82 to go to tour.
- Call preset 30 or preset 96 to stop scan or pattern.
- Call preset 31 or preset 83 to begin rotation.
- Call preset 33 to enable PTZ 180 degrees rotation.
- Call preset 34 to set dome position as 0.
- Set preset 26 or 92 to set scan left limit
- Set preset 27 or 93 to set scan right limit.
- Set preset 22 or 79 to begin record.
- Set preset 23 or 80 to stop record.
HD-CVI PTZs
Please note the IR speed dome can automatically recognize the industrial standard protocol, PELCO-D. PELCO-P. Usually you do not need to set the protocol.
