Difference between revisions of "Troubleshoot/NVR/Motion Record Troubleshoot"
(→Motion detection function does not work.) |
|||
| Line 15: | Line 15: | ||
* Ensure Working Period is set up and settings are saved | * Ensure Working Period is set up and settings are saved | ||
| − | [[File: | + | [[File:motiontrouble4.png|500px]] |
[[File:motiontrouble3.png|500px]] | [[File:motiontrouble3.png|500px]] | ||
Revision as of 15:25, 3 May 2016
Motion detection function does not work.
There are following possibilities:
- Period setup is not correct.
- Motion detection zone setup is not correct.
- Sensitivity is too low.
- Most third-party cameras will not have the full capabilities, like motion detection, to work.
- Check firmware.
- Default camera settings.
- Ensure motion detect set on the correct cameras.
- Ensure enable and record is checked off.
- Ensure Working Period is set up and settings are saved
