Difference between revisions of "Troubleshoot/NVR/Motion Record Troubleshoot"
(→Motion detection function does not work.) |
(→Motion detection function does not work.) |
||
| Line 7: | Line 7: | ||
* Most third-party cameras will not have the full capabilities, like motion detection, to work. | * Most third-party cameras will not have the full capabilities, like motion detection, to work. | ||
* Check firmware. | * Check firmware. | ||
| − | * Default camera settings. | + | * Default camera settings. |
| + | |||
| + | [[File:[[File:motiontrouble5.png|500px]] | ||
| + | |||
* Ensure motion detect set on the correct cameras. | * Ensure motion detect set on the correct cameras. | ||
* Ensure enable and record is checked off. | * Ensure enable and record is checked off. | ||
Revision as of 16:11, 4 May 2016
Motion detection function does not work.
There are following possibilities:
- Period setup is not correct.
- Motion detection zone setup is not correct.
- Sensitivity is too low.
- Most third-party cameras will not have the full capabilities, like motion detection, to work.
- Check firmware.
- Default camera settings.
[[File:
- Ensure motion detect set on the correct cameras.
- Ensure enable and record is checked off.
- Ensure Working Period is set up and settings are saved
