Difference between revisions of "Troubleshoot/NVR/Motion Record Troubleshoot"
(→Motion detection function does not work.) |
(→Motion detection function does not work.) |
||
Line 7: | Line 7: | ||
[[File:motiontrouble6.png|500px]] | [[File:motiontrouble6.png|500px]] | ||
− | [[File: | + | [[File:motiontrouble7.png|500px]] |
* Sensitivity is too low. | * Sensitivity is too low. |
Revision as of 18:11, 4 May 2016
Motion detection function does not work.
There are following possibilities:
- Period setup is not correct.
- Motion detection zone setup is not correct.
- Sensitivity is too low.
- Most third-party cameras will not have the full capabilities, like motion detection, to work.
- Check firmware.
- Default camera settings.
- Ensure motion detect set on the correct cameras.
- Ensure enable and record is checked off.
- Ensure Working Period is set up and settings are saved