Difference between revisions of "Troubleshoot/NVR/Motion Record Troubleshoot"
(→Motion detection function does not work.) |
(→Motion detection function does not work.) |
||
Line 1: | Line 1: | ||
===Motion detection function does not work.=== | ===Motion detection function does not work.=== | ||
There are following possibilities: | There are following possibilities: | ||
+ | |||
* Sensitivity is too low. | * Sensitivity is too low. | ||
* Most third-party cameras will not have the full capabilities, like motion detection, to work. | * Most third-party cameras will not have the full capabilities, like motion detection, to work. | ||
Line 11: | Line 12: | ||
[[File:motiontrouble8.png|500px]] | [[File:motiontrouble8.png|500px]] | ||
− | |||
* Motion detection zone setup is not correct. | * Motion detection zone setup is not correct. | ||
Revision as of 18:24, 4 May 2016
Motion detection function does not work.
There are following possibilities:
- Sensitivity is too low.
- Most third-party cameras will not have the full capabilities, like motion detection, to work.
- Check if firmware of Recorder and IP camera is current.
- Ensure motion detect set on the correct cameras.
- Period setup is not correct.
- Motion detection zone setup is not correct.
- Default camera settings.
- Ensure enable and record is checked off.
- Ensure Working Period is set up and settings are saved