Difference between revisions of "Troubleshoot/NVR/Motion Record Troubleshoot"
(→Motion detection function does not work.) |
(→Motion detection function does not work.) |
||
| Line 8: | Line 8: | ||
* Period setup is not correct. | * Period setup is not correct. | ||
| − | [[File:motiontrouble111.png| | + | [[File:motiontrouble111.png|500px]] |
| − | [[File: | + | |
| + | [[File:motiontrouble112.png|500px]] | ||
| − | |||
| − | |||
* Motion detection zone setup is not correct. | * Motion detection zone setup is not correct. | ||
| − | [[File:motiontrouble113.png|500px]] | + | [[File:motiontrouble113.png|500px]] |
| − | |||
| − | [[File:motiontrouble114 | + | [[File:motiontrouble114.png|500px]] |
| − | |||
* Try defaulting camera settings. | * Try defaulting camera settings. | ||
| Line 33: | Line 30: | ||
[[File:motiontrouble116.png|500px]] | [[File:motiontrouble116.png|500px]] | ||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
* Ensure the schedule is set for motion recording. | * Ensure the schedule is set for motion recording. | ||
Revision as of 15:50, 6 May 2016
Motion detection function does not work.
There are following possibilities:
- Sensitivity is too low.
- Most third-party cameras will not have the full capabilities, like motion detection, to work.
- Check if firmware of Recorder and IP camera is current.
- Ensure motion detect set on the correct cameras.
- Period setup is not correct.
- Motion detection zone setup is not correct.
- Try defaulting camera settings.
- If it is an IP Camera login in via web and try defaulting from there to see if it works.
- Ensure enable and record is checked off applied and saved.
- Ensure the schedule is set for motion recording.
