Difference between revisions of "Troubleshoot/NVR/Motion Record Troubleshoot"
(→Motion detection function does not work.) |
(→Motion detection function does not work.) |
||
| Line 11: | Line 11: | ||
[[File:motiontrouble112.png|500px]] | [[File:motiontrouble112.png|500px]] | ||
| − | |||
* Motion detection zone setup is not correct. | * Motion detection zone setup is not correct. | ||
| Line 33: | Line 32: | ||
* Ensure the schedule is set for motion recording. | * Ensure the schedule is set for motion recording. | ||
| − | [[File: | + | [[File:motiontrouble117.png|500px]] |
| − | [[File: | + | [[File:motiontrouble118.png|500px]] |
[[Category:Record]] | [[Category:Record]] | ||
[[Category:Troubleshoot]] | [[Category:Troubleshoot]] | ||
Revision as of 15:54, 6 May 2016
Motion detection function does not work.
There are following possibilities:
- Sensitivity is too low.
- Most third-party cameras will not have the full capabilities, like motion detection, to work.
- Check if firmware of Recorder and IP camera is current.
- Ensure motion detect set on the correct cameras.
- Period setup is not correct.
- Motion detection zone setup is not correct.
- Try defaulting camera settings.
- If it is an IP Camera login in via web and try defaulting from there to see if it works.
- Ensure enable and record is checked off applied and saved.
- Ensure the schedule is set for motion recording.
