Notice: Firmware Links Under Maintenance We are currently undergoing maintenance on all firmware links. If any links are inaccessible, please email or contact Tech Support for the firmware. We appreciate your patience during the maintenance, thank you for your understanding.
Difference between revisions of "Troubleshoot/NVR/Motion Record Troubleshoot"
(→Motion detection function does not work.) |
(→Motion detection function does not work.) |
||
| Line 19: | Line 19: | ||
[[File:motiontrouble113.png|500px]] | [[File:motiontrouble113.png|500px]] | ||
| − | Here you have a total of 4 regions you can set for each camera view. In each region you can set the sensitivity and threshold different levels. | + | Here on the region settings you have a total of 4 regions you can set for each camera view. In each region you can set the sensitivity and threshold different levels. |
[[File:motiontrouble114.png|500px]] | [[File:motiontrouble114.png|500px]] | ||
Revision as of 16:33, 10 May 2016
Motion detection function does not work.
There are following possibilities:
- Sensitivity is too low.
- Most third-party cameras will not have the full capabilities, like motion detection, to work.
- Check if firmware of Recorder and IP camera is current.
- Ensure motion detect is enabled on each camera, applied and saved.
- Period setup is not correct.
- Motion detection region setup is not correct.
Here on the region settings you have a total of 4 regions you can set for each camera view. In each region you can set the sensitivity and threshold different levels.
- Try defaulting camera settings.
- If it is an IP Camera login in via web and try defaulting from there to see if defaulting fixes the issue.
- Ensure enable and record is checked off applied and saved.
- Ensure the schedule is set for motion recording.
