Difference between revisions of "SmartPSS/Add Device P2P"
(→Pre-Requisites) |
(→Pre-Requisites) |
||
Line 2: | Line 2: | ||
===Pre-Requisites=== | ===Pre-Requisites=== | ||
* SN Number of device located on bottom of device recorder. Can also be located under menu -> system info from the local menu of the recorder. | * SN Number of device located on bottom of device recorder. Can also be located under menu -> system info from the local menu of the recorder. | ||
+ | * P2P must be enabled from the main menu of the recorder. Under Settings -> Network -> P2P. | ||
===Video Instructions=== | ===Video Instructions=== |
Revision as of 16:24, 29 June 2016
Contents
[hide | ◄ ► ]Setup Remote Access via P2P using SmartPSS
Pre-Requisites
- SN Number of device located on bottom of device recorder. Can also be located under menu -> system info from the local menu of the recorder.
- P2P must be enabled from the main menu of the recorder. Under Settings -> Network -> P2P.
Video Instructions
Step by Step Instructions
1. Locate the serial number of your NVR or DVR. The serial number can be found at the following locations:
- On the underside or side of the unit
- In the web interface, under Info->Version
- On the system interface under Main Menu->Settings->Network->P2P
- On the system interface under Main Menu->Info->System->Version
2. Launch SmartPSS. (Default SmartPSS credentials are admin:admin)
3. Click, "Devices"
4. Click, "Manual Add"
5. Input the following:
- Device Name:(Any Name)
- Register Mode: SN
- SN: (Your Device's Serial)
- Group Name: (Any Group)
- User Name: admin
- Password: admin (Your NVR's Password)
6. Click, "Get Info"
7. Click, "Save and Continue"
8. After a few moments, SmartPSS will connect to the NVR and display as, "Online"