Difference between revisions of "SmartPSS/Menu/Device CFG"

Revision as of 17:26, 6 September 2016 (view source) Nathan (talk | contribs) (→‎Maintenance) ← Older edit		Revision as of 17:30, 6 September 2016 (view source) Nathan (talk | contribs) (→‎Encode) Newer edit →
Line 62:		Line 62:
	=====Encode=====		=====Encode=====
−
−	*'''Audio/Video'''
−
	[[File:spssdevcfg009.jpg|800px]]		[[File:spssdevcfg009.jpg|800px]]

---

Revision as of 17:30, 6 September 2016

SmartPSS Menu-Device Config

Description

The Device Config menu is used to change the settings on IP cameras and NVR's. Follow the instructions below to learn about device configuration through SmartPSS.

Prerequisites

• SmartPSS Installed on computer
• Connected device such as an IP camera or NVR
• Device added onto SmartPSS successfully

Video Instructions

Step by Step Instructions

1. Launch SmartPSS and on the home page click DEVICE CFG.

2. On the left column click your designated device to configure.

3. Follow Each section below to access the specific Setting:

General

Network

• TCP/IP: Enter this section to configure the systems IPV4 and IPV6 network settings, you can also enable or disable DHCP here.

• Connect: Enter this section to configure the Max connections and

• PPPoE:'

• DDNS

• IP Filter

• SMTP

• FTP

• Multicast

• Alarm Centre

Remote Devices

Encode

Image

PTZ Control

Event

Video Detect

Alarm

Abnormality

Storage

Record

HDD

Maintenance

Account

Maintenance

WEB

Related Links