Difference between revisions of ":Face Detect"

Revision as of 22:45, 22 March 2017

Face Detect

Description

Face detection is to detect if there is any human face appearing in the video, and capture the face then send it to the NVR for analysis and processing, it can activate snapshot, record and alarm.

Internet Explorer Setup

Prerequisites

• Intelligent Network Camera.
• Updated firmware that supports intelligent features.
• Internet Explorer.

Video Instructions

Step by Step Instructions

1. Click “Enable”.

2. Click face enhancement to enhance the face image display.

3. Select max and min size, draw max and min target for target filtering. This step is to filter target, which can’t be operated under default status.

4. Activate record, alarm, email and snapshot according to the requirements.

5. Target filter can set max target and min target, which means it can detect max and min target.

6. Click ok to complete settings.

System Interface Setup

Prerequisites

Video Instructions

Step by Step Instructions

1. Go to Event.

2. Enable Face detect under IVS and then hit apply and save.

SmartPSS Setup

Prerequisites

• SmartPSS 2.0
• IVS capable device with Face Detection
• Upgraded devices to latest firmware

Smart PSS Video Instructions

Step by Step Instructions

1. Launch and Log into Smart PSS

600px

2. Select "Live".

600px

3. From Live View Select Device that is IVS capable -> right click on device and select IVS Config.

600px

4. Select Face detection -> Select Next.

600px

5.Draw a Detection Zone

600px

6. Select Config for arming schedule and choose what days Face Detect is to be enabled.

600px

7. Select Alarm -> Choose alarm type such as Record -> Select Save

600px

8.Select Target Filter -> Select Enable -> Choose either "Width and Height or Width and Height" -> Select Draw to size the target filter (Inner green box size is minimum target, Outer green box is the maximum target) -> Apply and Save.

600px