Difference between revisions of "NVR/Recording Setup/Alarm Recording Setup SmartPSS 2.0"

(Description)
(Step by Step Instructions)
Line 33: Line 33:
  
 
[[file:PhysicalAlarmRecordSetup11Large.JPG|600px]]
 
[[file:PhysicalAlarmRecordSetup11Large.JPG|600px]]
 +
 +
4. Log into SmartPSS -> Select "Device Configuration" from the home page.

Revision as of 20:41, 13 October 2017

How to Setup Alarm Recording Using A Physical Alarm via SmartPSS 2.0

Description

How to Setup Alarm Recording Using A Physical Alarm via SmartPSS 2.0

Prerequisites

  • A NVR or IP Camera with an Alarm Out

PhysicalAlarmRecordSetup8Large.JPG

  • A low voltage physical alarm

PhysicalAlarmRecordSetup1Large.JPG

  • Dual pair 24 gauge run to the physical alarm

PhysicalAlarmRecordSetup15Large.JPG

  • Alarm block

PhysicalAlarmRecordSetup6Large.JPG

Step by Step Instructions

1. Identify which alarm out block you wish to use to connect your physical alarm. For this example we are going to use, "Alarm Out Channel 1"

PhysicalAlarmRecordSetup14.JPG

2. Connect the cable to your physical alarm.

PhysicalAlarmRecordSetup9Large.JPG->PhysicalAlarmRecordSetup10Large.JPG

3. Connect the cable to the alarm block on the ports labeled, "IN1" and "Ground"

PhysicalAlarmRecordSetup11Large.JPG

4. Log into SmartPSS -> Select "Device Configuration" from the home page.