Difference between revisions of "NVR/Basic Setup/Set IP Address"

Revision as of 00:48, 2 February 2016

Connect a RJ45 cable from camera to NVRThen connect a RJ45 cable from NVR to PC.

Go to wifi to be on the same network as the camera.

Go and find the IP address of the camera using the config tool.

Set the IP address of the laptop same as the camera.

Here's how: Step 1:

Step 2:

Step 3:

Step 4:

Then you can proceed to configure the camera such as an firmware upgrade.

@@ Line 1: / Line 1: @@
 ==How to set IP address for configuring IP cameras==
-Connect a RJ45 cable from the camera to your PC.
+Connect a RJ45 cable from camera to NVRThen connect a RJ45 cable from NVR to PC.
 Go to wifi to be on the same network as the camera.
@@ Line 10: / Line 10: @@
 Here's how:
-Open up network and sharing center
+Step 1:
+[[File:IPCSetIP1.jpg|none]]
-Step 1: Click on adapter settings
+Step 2:
+[[File:IPCSetIP2.jpg|none]]
-[[File:IPCSetIP1.jpg]]
+Step 3:
+[[File:IPCSetIP3.jpg|none]]
-Step 2: Click on Ethernet
+Step 4:
+[[File:IPCSetIP4.jpg|none]]
-[[File:IPCSetIP2.jpg]]
-Step 3: Internet Protocol version 4
-[[File:IPCSetIP3.jpg]]
-Step 4: Properties
-[[File:IPCSetIP4.png]]
-Step 5: Make sure you put it on use the following IP address!
-[[File:IPCSetIP5.png | none]]
 Then you can proceed to configure the camera such as an firmware upgrade.