Difference between revisions of "Alarm Config Settings"

Revision as of 16:03, 30 October 2020

Alarms of various types (such as Motion) can be setup and configured to respond in different ways when triggered.

Configure the alarm trigger/response on the same interface where the Alarm is setup:

The settings are explained below:

Setting	Description
Period	Sets the time and days of the week this alarm can be triggered
Post-Record	Sets the amount of seconds that are recorded after the alarm event is done being triggered, if "Record Channel" is enabled
Alarm Out	Sets alarm outputs that will be activate when this alarm is triggered > How To Set Up Alarm Output
Record Channel	Sets which channels are recorded when the alarm is triggered
Tour	Enables a tour when the alarm is triggered
PTZ Activation	Sets the behavior of a PTZ camera connected to the same recorder when the alarm is triggered > How To Set Up PTZ Activation
Buzzer	Makes the recorder emit an audible beeping noise when the alarm is triggered
Alarm Upload
Log	Records the event information in the system log when the alarm is triggered
Send Email	Sends an email, via the settings set in the Email section of the Network settings on the recorder, when the alarm is triggered > How To Set Up Email Notifications

@@ Line 2: / Line 2: @@
 Alarms of various types (such as Motion) can be setup and configured to respond in different ways when triggered.
-Configure the alarm trigger on the same interface where the Alarm is setup:
+Configure the alarm trigger/response on the same interface where the Alarm is setup:
 [[File:Alarm_Trigger_menu_SystemUI.jpg|500px]]
 </center>
+The settings are explained below:
 {| class="wikitable" style="font-weight:bold; font-size:medium;"