Difference between revisions of "Troubleshoot/NVR/Motion Record Troubleshoot"
(→Motion detection function does not work.) |
(→Motion detection function does not work.) |
||
| Line 13: | Line 13: | ||
[[File:motiontrouble1.png|500px]] | [[File:motiontrouble1.png|500px]] | ||
| − | * Ensure Working Period is set up | + | * Ensure Working Period is set up and settings are saved |
| − | + | ||
[[File:motiontrouble2.png|500px]] | [[File:motiontrouble2.png|500px]] | ||
| + | |||
| + | [[File:motiontrouble3.png|500px]] | ||
[[Category:Record]] | [[Category:Record]] | ||
[[Category:Troubleshoot]] | [[Category:Troubleshoot]] | ||
Revision as of 15:20, 3 May 2016
Motion detection function does not work.
There are following possibilities:
- Period setup is not correct.
- Motion detection zone setup is not correct.
- Sensitivity is too low.
- Most third-party cameras will not have the full capabilities, like motion detection, to work.
- Check firmware.
- Default camera settings.
- Ensure motion detect set on the correct cameras.
- Ensure enable and record is checked off.
- Ensure Working Period is set up and settings are saved
