Notice: Firmware Links Under Maintenance We are currently undergoing maintenance on all firmware links. If any links are inaccessible, please email or contact Tech Support for the firmware. We appreciate your patience during the maintenance, thank you for your understanding.
Difference between revisions of "Troubleshoot/NVR/Motion Record Troubleshoot"
(→Motion detection function does not work.) |
(→Motion detection function does not work.) |
||
| Line 11: | Line 11: | ||
* Sensitivity is too low. | * Sensitivity is too low. | ||
* Most third-party cameras will not have the full capabilities, like motion detection, to work. | * Most third-party cameras will not have the full capabilities, like motion detection, to work. | ||
| − | * Check firmware. | + | * Check if firmware of Recorder and IP camera is current. |
* Default camera settings. | * Default camera settings. | ||
Revision as of 18:12, 4 May 2016
Motion detection function does not work.
There are following possibilities:
- Period setup is not correct.
- Motion detection zone setup is not correct.
- Sensitivity is too low.
- Most third-party cameras will not have the full capabilities, like motion detection, to work.
- Check if firmware of Recorder and IP camera is current.
- Default camera settings.
- Ensure motion detect set on the correct cameras.
- Ensure enable and record is checked off.
- Ensure Working Period is set up and settings are saved
