Difference between revisions of "Troubleshoot/NVR/Motion Record Troubleshoot"
(→Motion detection function does not work.) |
|||
| Line 31: | Line 31: | ||
[[File:motiontrouble3.png|500px]] | [[File:motiontrouble3.png|500px]] | ||
| + | |||
| + | Ensure the the schedule is set for motion recording. | ||
| + | |||
| + | [[File:motiontrouble10.png|500px]] | ||
| + | |||
| + | [[File:motiontrouble11.png|500px]] | ||
[[Category:Record]] | [[Category:Record]] | ||
[[Category:Troubleshoot]] | [[Category:Troubleshoot]] | ||
Revision as of 18:39, 4 May 2016
Motion detection function does not work.
There are following possibilities:
- Sensitivity is too low.
- Most third-party cameras will not have the full capabilities, like motion detection, to work.
- Check if firmware of Recorder and IP camera is current.
- Ensure motion detect set on the correct cameras.
- Period setup is not correct.
- Motion detection zone setup is not correct.
- Default camera settings.
- Ensure enable and record is checked off and saved.
- Ensure Working Period is set up and settings are saved
Ensure the the schedule is set for motion recording.
