Notice: Firmware Links Under Maintenance We are currently undergoing maintenance on all firmware links. If any links are inaccessible, please email or contact Tech Support for the firmware. We appreciate your patience during the maintenance, thank you for your understanding.
Difference between revisions of "Troubleshoot/NVR/Motion Record Troubleshoot"
(→Motion detection function does not work.) |
(→Motion detection function does not work.) |
||
| Line 8: | Line 8: | ||
* Period setup is not correct. | * Period setup is not correct. | ||
| − | [[File:motiontrouble111.png| | + | [[File:motiontrouble111.png|480px]] |
[[File:motiontrouble8.png|500px]] | [[File:motiontrouble8.png|500px]] | ||
Revision as of 15:09, 6 May 2016
Motion detection function does not work.
There are following possibilities:
- Sensitivity is too low.
- Most third-party cameras will not have the full capabilities, like motion detection, to work.
- Check if firmware of Recorder and IP camera is current.
- Ensure motion detect set on the correct cameras.
- Period setup is not correct.
- Motion detection zone setup is not correct.
- Try defaulting camera settings.
- Ensure enable and record is checked off and saved.
- Ensure Working Period is set up and settings are saved
- Ensure the schedule is set for motion recording.
