Difference between revisions of "Troubleshoot/NVR/Motion Record Troubleshoot"

(→‎Motion detection function does not work.)
Line 22: Line 22:
 
[[File:motiontrouble115.png|500px]] 
 
[[File:motiontrouble115.png|500px]] 
  
−
* If it is an IP Camera login in via web and try defaulting from there to see if it works.
+
* If it is an IP Camera login in via web and try defaulting from there to see if defaulting fixes the issue.
  
 
[[File:motiontrouble5.png|500px]] 
 
[[File:motiontrouble5.png|500px]] 

Revision as of 16:16, 6 May 2016

Motion detection function does not work.

There are following possibilities:

  • Sensitivity is too low.
  • Most third-party cameras will not have the full capabilities, like motion detection, to work.
  • Check if firmware of Recorder and IP camera is current.
  • Ensure motion detect set on the correct cameras.
  • Period setup is not correct.

Motiontrouble111.png

Motiontrouble112.png

  • Motion detection zone setup is not correct.

Motiontrouble113.png  

Motiontrouble114.png

  • Try defaulting camera settings.

Motiontrouble115.png 

  • If it is an IP Camera login in via web and try defaulting from there to see if defaulting fixes the issue.

Motiontrouble5.png 

  • Ensure enable and record is checked off applied and saved.

Motiontrouble116.png

  • Ensure the schedule is set for motion recording.

Motiontrouble117.png

Motiontrouble118.png

Retrieved from "https://DahuaWiki.com/index.php?title=Troubleshoot/NVR/Motion_Record_Troubleshoot&oldid=10152"