Difference between revisions of "Troubleshoot/NVR/Motion Record Troubleshoot"

(→‎Motion detection function does not work.)
(→‎Motion detection function does not work.)
Line 19: Line 19:
 
[[File:motiontrouble113.png|500px]]  
 
[[File:motiontrouble113.png|500px]]  
  
−
Here you have a total of 4 regions you can set for each camera view. In each region you can set the sensitivity and threshold different levels.   
+
Here on the region settings you have a total of 4 regions you can set for each camera view. In each region you can set the sensitivity and threshold different levels.   
  
 
[[File:motiontrouble114.png|500px]]
 
[[File:motiontrouble114.png|500px]]

Revision as of 16:33, 10 May 2016

Motion detection function does not work.

There are following possibilities:

  • Sensitivity is too low.
  • Most third-party cameras will not have the full capabilities, like motion detection, to work.
  • Check if firmware of Recorder and IP camera is current.
  • Ensure motion detect is enabled on each camera, applied and saved.

Motiontrouble120.png

  • Period setup is not correct.

Motiontrouble111.png

Motiontrouble112.png

  • Motion detection region setup is not correct.

Motiontrouble113.png  

Here on the region settings you have a total of 4 regions you can set for each camera view. In each region you can set the sensitivity and threshold different levels.

Motiontrouble114.png

Motiontrouble119.png

  • Try defaulting camera settings.

Motiontrouble115.png 

  • If it is an IP Camera login in via web and try defaulting from there to see if defaulting fixes the issue.

Motiontrouble5.png 

  • Ensure enable and record is checked off applied and saved.

Motiontrouble116.png

  • Ensure the schedule is set for motion recording.

Motiontrouble117.png

Motiontrouble118.png

Retrieved from "https://DahuaWiki.com/index.php?title=Troubleshoot/NVR/Motion_Record_Troubleshoot&oldid=10277"