Difference between revisions of "NVR/Recording Setup/Alarm Recording Setup"
| Line 1: | Line 1: | ||
==How to Setup Alarm Recording Using A Physical Alarm== | ==How to Setup Alarm Recording Using A Physical Alarm== | ||
| − | + | ||
| − | === | + | ===Prerequisites=== |
* A NVR or IP Camera with an Alarm Out | * A NVR or IP Camera with an Alarm Out | ||
| Line 18: | Line 18: | ||
[[file:PhysicalAlarmRecordSetup6Large.JPG|600px]] | [[file:PhysicalAlarmRecordSetup6Large.JPG|600px]] | ||
| − | === | + | ===Video Instructions=== |
| + | <embedvideo service="youtube">https://youtu.be/ZrMtWrNTTH4</embedvideo> | ||
| + | ===Step by Step Instructions=== | ||
1. Identify which alarm out block you wish to use to connect your physical alarm. For this example we are going to use, "Alarm Out Channel 1" | 1. Identify which alarm out block you wish to use to connect your physical alarm. For this example we are going to use, "Alarm Out Channel 1" | ||
Revision as of 21:11, 25 July 2016
Contents
How to Setup Alarm Recording Using A Physical Alarm
Prerequisites
- A NVR or IP Camera with an Alarm Out
- A low voltage physical alarm
- Dual pair 24 gauge run to the physical alarm
- Alarm block
Video Instructions
Step by Step Instructions
1. Identify which alarm out block you wish to use to connect your physical alarm. For this example we are going to use, "Alarm Out Channel 1"
2. Connect the cable to your physical alarm.
->
3. Connect the cable to the alarm block on the ports labeled, "IN1" and "Ground"
4. Login to the NVR, and click, "Setup"
5. Click, "Event"
6. Click, "Alarm"
7. Select the Channel, and enable, "Local Alarm"
8. Select either, "NO" or "NC"
NO -Normally Open
NC -Normally Close
9. Next select what actions you want the system to perform, when the alarm is activated.
10. Click, "OK"
Links
| Related Articles in Category:Record | ||
|---|---|---|
|
<DynamicPageList> category = Record count=5 </DynamicPageList> |
<DynamicPageList> category = Record offset = 5 count= 5 </DynamicPageList> |
<DynamicPageList> category = Record offset = 10 count=5 </DynamicPageList> |
