Notice: Firmware Links Under Maintenance We are currently undergoing maintenance on all firmware links. If any links are inaccessible, please email or contact Tech Support for the firmware. We appreciate your patience during the maintenance, thank you for your understanding.
Difference between revisions of "IRLight"
(→IR effect is bad.) |
(→IR effect is bad.) |
||
| Line 6: | Line 6: | ||
# Check if camera IR is set to auto. | # Check if camera IR is set to auto. | ||
# IR is not illuminating powerful enough. Make sure the plastic is off the lens. The plastic can affect the effectiveness of the IR. | # IR is not illuminating powerful enough. Make sure the plastic is off the lens. The plastic can affect the effectiveness of the IR. | ||
| − | # IR glare. Check if there are debris on the cameras glass. Debris | + | # IR glare. Check if there are debris on the cameras glass. Debris can cause infrared glare. |
[[Category:Troubleshoot]][[Category:Camera]] | [[Category:Troubleshoot]][[Category:Camera]] | ||
[[Category:IP Camera]] | [[Category:IP Camera]] | ||
[[Category:Camera Troubleshoot]] | [[Category:Camera Troubleshoot]] | ||
Revision as of 17:04, 3 August 2016
IR effect is bad.
- Failed to enable all IR lights. Make sure the specified power supply is used.
- The object is so far that it is out of the range of IR light.
- IR-CUT is set as color mode, which caused the front-end sensor to fail to sense IR light.
- When you use the device on the table (especially rough surface), the IR light will shoot back to the lens, which will cause bad IR effect and white picture. At this moment, you should adjust the elevation angle of the lens or place the device on the edge.
- Check if camera IR is set to auto.
- IR is not illuminating powerful enough. Make sure the plastic is off the lens. The plastic can affect the effectiveness of the IR.
- IR glare. Check if there are debris on the cameras glass. Debris can cause infrared glare.
