Difference between revisions of "SmartPSS/Menu/Device CFG"
(→PTZ Control) |
(→Event) |
||
| Line 74: | Line 74: | ||
====Event==== | ====Event==== | ||
| − | |||
=====Video Detect===== | =====Video Detect===== | ||
| − | + | [[File:spssdevcfg019|800px]] | |
=====Alarm===== | =====Alarm===== | ||
| − | + | [[File:spssdevcfg008|800px]] | |
=====Abnormality===== | =====Abnormality===== | ||
| + | [[File:spssdevcfg022|800px]] | ||
====Storage==== | ====Storage==== | ||
Revision as of 16:50, 6 September 2016
Contents
SmartPSS Menu-Device Config
Description
The Device Config menu is used to change the settings on IP cameras and NVR's. Follow the instructions below to learn about device configuration through SmartPSS.
Prerequisites
- SmartPSS Installed on computer
- Connected device such as an IP camera or NVR
- Device added onto SmartPSS successfully
Video Instructions
Step by Step Instructions
1. Launch SmartPSS and on the home page click DEVICE CFG.
2. On the left column click your designated device to configure.
3. Follow Each section below to access the specific Setting:
General
Network
- TCP/IP: Enter this section to configure the systems IPV4 and IPV6 network settings, you can also enable or disable DHCP here.
- Connect: Enter this section to configure the Max connections and
- PPPoE:'
- DDNS
- IP Filter
- SMTP
- FTP
- Multicast
- Alarm Centre
Remote Devices
Encode
- Audio/Video
Image
PTZ Control
