Difference between revisions of "NVR/Basic Setup/Initial Setup"
(Created page with "<pdf>File:Standalone_DVR_Quick_Start_Guide_V1.0.0.pdf</pdf>") |
|||
| Line 1: | Line 1: | ||
| − | + | File:Standalone_DVR_Quick_Start_Guide_V1.0.0.pdf | |
| + | ===Boot up and Shutdown=== | ||
| + | ====Boot up==== | ||
| + | Before the boot up, please make sure: | ||
| + | *For device security, please connect the NVR to the power adapter first and then connect the device to the power socket. | ||
| + | *The rated input voltage matches the device power on-off button. Please make sure the power wire connection is OK. Then click the power on-off button. | ||
| + | *Always use the stable current, if necessary UPS is a best alternative measure. | ||
| + | Please follow the steps listed below to boot up the device. | ||
| + | *Connect the device to the monitor and then connect a mouse. | ||
| + | *Connect power cable. | ||
| + | *Click the power button at the front or rear panel and then boot up the device. After device booted up, the system is in multiple-channel display mode by default. | ||
Revision as of 16:30, 23 October 2015
File:Standalone_DVR_Quick_Start_Guide_V1.0.0.pdf
Boot up and Shutdown
Boot up
Before the boot up, please make sure:
- For device security, please connect the NVR to the power adapter first and then connect the device to the power socket.
- The rated input voltage matches the device power on-off button. Please make sure the power wire connection is OK. Then click the power on-off button.
- Always use the stable current, if necessary UPS is a best alternative measure.
Please follow the steps listed below to boot up the device.
- Connect the device to the monitor and then connect a mouse.
- Connect power cable.
- Click the power button at the front or rear panel and then boot up the device. After device booted up, the system is in multiple-channel display mode by default.
