Notice: Firmware Links Under Maintenance We are currently undergoing maintenance on all firmware links. If any links are inaccessible, please email or contact Tech Support for the firmware. We appreciate your patience during the maintenance, thank you for your understanding.
Difference between revisions of "NVR/Recording Setup/Alarm Recording Setup SmartPSS 1.6"
(→Step by Step Instructions) |
(→Step by Step Instructions) |
||
| Line 22: | Line 22: | ||
[[file:PhysicalAlarmRecordSetup11Large.JPG|600px]] | [[file:PhysicalAlarmRecordSetup11Large.JPG|600px]] | ||
| − | 4. Log into SmartPSS -> | + | 4. Log into SmartPSS -> Device CFG. |
[[file:alarmsmartpss1_16.png|600px]] | [[file:alarmsmartpss1_16.png|600px]] | ||
| + | |||
| + | [[file:alarmsmartpss1_16_2.png|600px]] | ||
Revision as of 19:11, 12 October 2017
Description
SmartPSS 1.6 Alarm Setup
Prerequisites
- A NVR or IP Camera with an Alarm Out
- SmartPSS 1.16 or 1.161
Video Instructions
Step by Step Instructions
1. Identify which alarm out block you wish to use to connect your physical alarm. For this example we are going to use, "Alarm Out Channel 1"
2. Connect the cable to your physical alarm.
->
3. Connect the cable to the alarm block on the ports labeled, "IN1" and "Ground"
4. Log into SmartPSS -> Device CFG.
