Notice: Firmware Links Under Maintenance We are currently undergoing maintenance on all firmware links. If any links are inaccessible, please email or contact Tech Support for the firmware. We appreciate your patience during the maintenance, thank you for your understanding.
Difference between revisions of "NVR/Recording Setup/Alarm Recording Setup SmartPSS 1.6"
(→Step by Step Instructions) |
(→Step by Step Instructions) |
||
Line 47: | Line 47: | ||
[[file:alarmsmartpss1_16_7.png|600px]] | [[file:alarmsmartpss1_16_7.png|600px]] | ||
+ | |||
+ | 9. Select Apply and Save to save settings. |
Revision as of 22:19, 12 October 2017
Description
SmartPSS 1.6 Alarm Setup
Prerequisites
- A NVR or IP Camera with an Alarm Out
- SmartPSS 1.16 or 1.161
Video Instructions
Step by Step Instructions
1. Identify which alarm out block you wish to use to connect your physical alarm. For this example we are going to use, "Alarm Out Channel 1"
2. Connect the cable to your physical alarm.
3. Connect the cable to the alarm block on the ports labeled, "IN1" and "Ground"
4. Log into SmartPSS -> Device CFG.
5. From left hand side select recorder -> Under event select alarm.
6. Check mark Alarm Input Enable -> Select channel.
7. Select either, "NO" or "NC"
8. Next select what actions you want the system to perform, when the alarm is activated.
9. Select Apply and Save to save settings.