Difference between revisions of "NVR/Recording Setup/Alarm Recording Setup SmartPSS 1.6"
(→Step by Step Instructions) |
(→Description) |
||
| Line 1: | Line 1: | ||
==Description== | ==Description== | ||
| − | SmartPSS 1.6 Alarm Setup | + | SmartPSS 1.6 Alarm Setup |
===Prerequisites=== | ===Prerequisites=== | ||
| Line 44: | Line 44: | ||
[[file:alarmsmartpss1_16_6.png|600px]] | [[file:alarmsmartpss1_16_6.png|600px]] | ||
| − | 8. Next select what actions you want the system to perform, when the alarm is activated. | + | 8. Next select what actions you want the system to perform, when the alarm is activated. If recording of the alarm event is needed you will need to check mark "record". |
[[file:alarmsmartpss1_16_8.png|600px]] | [[file:alarmsmartpss1_16_8.png|600px]] | ||
Revision as of 22:52, 12 October 2017
Description
SmartPSS 1.6 Alarm Setup
Prerequisites
- A NVR or IP Camera with an Alarm Out
- SmartPSS 1.16 or 1.161
Video Instructions
Step by Step Instructions
1. Identify which alarm out block you wish to use to connect your physical alarm. For this example we are going to use, "Alarm Out Channel 1"
2. Connect the cable to your physical alarm.
->
3. Connect the cable to the alarm block on the ports labeled, "IN1" and "Ground"
4. Log into SmartPSS -> Device CFG.
5. From left hand side select recorder -> Under event select alarm.
6. Check mark Alarm Input Enable -> Select channel.
7. Select either, "NO" or "NC"
NO -Normally Open
NC -Normally Close
8. Next select what actions you want the system to perform, when the alarm is activated. If recording of the alarm event is needed you will need to check mark "record".
9. Select Apply and Save to save settings.
