Notice: Firmware Links Under Maintenance We are currently undergoing maintenance on all firmware links. If any links are inaccessible, please email or contact Tech Support for the firmware. We appreciate your patience during the maintenance, thank you for your understanding.
Difference between revisions of "Thermal/Calibrate Blackbody"
(→Step by Step Instructions) |
|||
Line 29: | Line 29: | ||
[[File:Thermal Monitoring Setup-4.png|800px]] | [[File:Thermal Monitoring Setup-4.png|800px]] | ||
− | Make sure the Blackbody box is set to 35°C to reflect the settings in the camera | + | Make sure the Blackbody box is set to 35°C (95°F) to reflect the settings in the camera |
[[File:Configure Blackbody-4.JPG|800px]] | [[File:Configure Blackbody-4.JPG|800px]] |
Revision as of 14:24, 30 April 2020
Contents
How to Configure the Blackbody
Description
This article will go over how to configure the Blackbody.
Prerequistes
- DH-TPC-BF3221-T or DH-TPC-BF5421-T Thermal Hybrid Network Camera
- JQ-D70Z Blackbody
Video Instructions
Step by Step Instructions
1. Login to the Thermal Camera
2. Go to Smart Thermal> Smart Plan> and enable Thermal Temperature Monitor. Save
3. On the left menu tab go to Thermal Temperature>Blackbody Parameter and enable.
- Leave the black box permanently at 35°C (95°F)
- Draw the area around the inner plate of the Blackbody box for accurate readings
Make sure the Blackbody box is set to 35°C (95°F) to reflect the settings in the camera