Difference between revisions of "Troubleshoot/NVR/No HDD"
| Line 23: | Line 23: | ||
SATA Cable | SATA Cable | ||
| − | [[file:harddrive1.jpg]] | + | [[file:harddrive1.jpg|500px]] |
SATA into Harddrive | SATA into Harddrive | ||
| − | [[file:harddrive2.jpg]] | + | [[file:harddrive2.jpg|500px]] |
SATA from motherboard to Harddrive | SATA from motherboard to Harddrive | ||
| − | [[file:harddrive3.jpg]] | + | [[file:harddrive3.jpg|500px]] |
[[File:HDD.jpg|right|alt=HDD|link=https://en.wikipedia.org/wiki/Hard_disk_drive]] | [[File:HDD.jpg|right|alt=HDD|link=https://en.wikipedia.org/wiki/Hard_disk_drive]] | ||
[[Category:Troubleshoot]] | [[Category:Troubleshoot]] | ||
[[Category:HDD]] | [[Category:HDD]] | ||
Revision as of 00:41, 3 May 2016
System can not detect hard disk.
There are following possibilities:
- HDD is broken.
- HDD ribbon is damaged.
- HDD cable connection is loose.
- Main board SATA port is broken.
- HDD is not compatible.
- Insufficient power.
Solutions
- Reboot Device.
- Disconnect the hard drive from the device, then boot it up with the HDD disconnected. If there are no errors when booting without a hard drive, then the hard drive is most likely the problem and needs to be replaced.
- Format HDD.
- Check HDD compatibility.
- Check HDD cables and if connections are secure.
- If SATA port is broken try another SATA port.
- Reset to device to factory settings.
- Make sure you have the correct power cable for the Device.
- Replace HDD.
- Open Casing and check jumper settings
SATA Cable
SATA into Harddrive
SATA from motherboard to Harddrive
Error creating thumbnail: Unable to save thumbnail to destination
