Troubleshoot/NVR/Motion Record Troubleshoot
Revision as of 18:10, 4 May 2016 by Mark (talk | contribs) (→Motion detection function does not work.)
Motion detection function does not work.
There are following possibilities:
- Period setup is not correct.
- Motion detection zone setup is not correct.
- Sensitivity is too low.
- Most third-party cameras will not have the full capabilities, like motion detection, to work.
- Check firmware.
- Default camera settings.
- Ensure motion detect set on the correct cameras.
- Ensure enable and record is checked off.
- Ensure Working Period is set up and settings are saved