EventAlarm

Revision as of 19:46, 14 October 2015 by JP (talk | contribs) (PIR Alarm)

Event Alarm

PIR Alarm

IPCEventPIRAlarm.jpg

Parameter

Function

Enable

After enabled, relay activation will work. Check it and enable the PIR alarm.

Working period

  • This function becomes activated in the specified periods.
  • There are six periods in one day. Please draw a circle to enable corresponding period.
  • Select date. If you do not select, current setup applies to today only. You can select all week column to apply to the whole week.
  • Click OK button, system goes back to motion detection interface; please click save button to exit.

Note: User can set via dragging mouse while not releasing left mouse.

Anti-dither

System only memorizes one event during the anti-dither period. The value ranges from 0s to 100s.

Flash

After enabling, the system will automatically turn on the flash when alarm occurs.

Flash Delay

  • The flash will be off with a period of time delay when the alarm linkage is over.
  • Time is calculated by unit of second and ranges from 10s~300s.

Record

System auto activates motion detection channel to record once alarm occurs (working with motion detection function).

Record Delay

System can delay the record for specified time after alarm ended. The value ranges from 10s to 300s.

Relay out

Enable alarm activation function. You need to select alarm output port so that system can activate corresponding alarm device when alarm occurs. 

Alarm delay

System can delay the alarm output for specified time after alarm ended. The value ranges from 10s to 300s.

Send Email

After this function is enabled, system can send out email to alert you when alarm occurs and ends.

Audio Linkage

Check it and the system will play alarm audio file when alarm occurs. Users can set recorded audio file in “Camera Setting >Audio >Alarm Audio”.

Snapshot

After you enabled snapshot, the system will automatically snapshot if alarm occurs.

Relay Activation

Flash Set

Audio Detect