:Step by Step Test
Contents
Step by Step Test
Device Initialization
NVR Device Initialization
WARNING!
Failure to setup, "Device Initialization" will result in an RMA, if you forget your password, and skipped this setup process.
Prerequisites
- Dahua NVR, DVR, or XVR running the latest firmware
- A display connected to your Dahua recorder
Video Instructions
Step by Step Instructions
4. Password Protection - Input an E-mail address to be able reset the password. Answer the security questions to complete the password protection setup.
Warning - Don't blow this off, it's your only way to reset the password. Master Codes no longer work.
5. End-User License Agreement - Read through the End-User License Agreement, when ready check the agreement box to enable "Next".
6. Firmware Updates - Check the "Enable auto detect" box to automatically check the latest firmware.
7. General Settings - You can set common general settings here. Click on "Apply" then "Next" when finished.
8. Date and Time - Make sure to properly set up your time zone to assure accurate time readings. You can also configure Daylight Saving Time (DST). When finished click on "Apply" and then click "Next" to proceed.
9. TCP/IP - To edit the IP Address on the recorder's NIC click on the pencil icon. You can now set a Static IP or enable DHCP to let the recorder grab an IP Address from the network, once done click "OK" and then "Next" to finish the setup.
10. Remote Access - P2P (Easy4IP): By checking this box, it will connect you to Dahua's P2P server and will allow you to remote to your device. If TCP/IP was set properly for your network, the status will show as "online".
NOTE The QR code on the left will direct you to the smartphone application. The QR code on the right will allow you scan the SN of your device.
11.Camera Registration - To initialize the device from the NVR check the camera(s) that you want and click on "Initialize" - Keep the box checked if you want to sync the password and E-mail to the camera and click on "Next"
Modify the IP Address and click on "Next" - Wait for the initialization to finish and the "Finished" button will activate, click on it to proceed.
Check the camera you just initialized and click on "Add"