NVR/Basic Setup/Set IP Address

Revision as of 18:40, 9 December 2015 by JP (talk | contribs)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

How to set IP address for configuring IP cameras

Connect a RJ45 cable from the camera to your PC.

Go to wifi to be on the same network as the camera.

Go and find the IP address of the camera using the config tool.

Set the IP address of the laptop same as the camera.

Here's how: Open up network and sharing center

Step 1: Click on adapter settings

Error creating thumbnail: Unable to save thumbnail to destination

Step 2: Click on Ethernet

Error creating thumbnail: Unable to save thumbnail to destination

Step 3: Internet Protocol version 4

Error creating thumbnail: Unable to save thumbnail to destination

Step 4: Properties

Error creating thumbnail: Unable to save thumbnail to destination

Step 5: Make sure you put it on use the following IP address!

Error creating thumbnail: Unable to save thumbnail to destination

Then you can proceed to configure the camera such as an firmware upgrade.

Retrieved from "https://DahuaWiki.com/index.php?title=NVR/Basic_Setup/Set_IP_Address&oldid=3469"