Troubleshoot/Internet Explorer ActiveX Setup

Configure Internet Explorer Security Settings

1. Open Internet Explorer.

Error creating thumbnail: Unable to save thumbnail to destination

2. Click on the gear icon in the upper right hand corner

Error creating thumbnail: Unable to save thumbnail to destination

3. Click, "Internet Options"

Error creating thumbnail: Unable to save thumbnail to destination

4. Click the, "Security" tab.

Error creating thumbnail: Unable to save thumbnail to destination

5. Click the, "Trusted sites" icon.

Error creating thumbnail: Unable to save thumbnail to destination

6. Click the, "Sites" box immediately below the zones.

Error creating thumbnail: Unable to save thumbnail to destination

7. Input your devices IP address into the top box, click, "Add" and then, "Close"

Error creating thumbnail: Unable to save thumbnail to destination

8. Click, "Custom level..."

Error creating thumbnail: Unable to save thumbnail to destination

9. Click the drop down box at the bottom of this window, and change the setting to, "Low"

Error creating thumbnail: Unable to save thumbnail to destination

=>

Error creating thumbnail: Unable to save thumbnail to destination

10. Click, "Reset" and then, "Yes" in the confirmation dialogue.

Error creating thumbnail: Unable to save thumbnail to destination

11. Click on the, "Advanced" tab.

Error creating thumbnail: Unable to save thumbnail to destination

12. Ensure the following are ENABLED:

• Browsing->Enable third-party browser extensions
• Security->Allow software to run or install even if the signature is invalid

Error creating thumbnail: Unable to save thumbnail to destination

Error creating thumbnail: Unable to save thumbnail to destination

13. Click, "Apply" and then, "OK"

Error creating thumbnail: Unable to save thumbnail to destination

14. Reboot your computer, and try to access your system.