SmartPSS/Face Detect

NOTICE

Notice of Discontinuation of SmartPSS

How To Use Face Detect In SmartPSS

Description

This article will show you how to use the Face Detect feature on a supported device using SmartPSS

Prerequisites

• SmartPSS
• Supported device with Face Detect feature
• Device added to SmartPSS Device List - How To Add Device to SmartPSS

Step by Step Instructions

1. Launch SmartPSS.

2. Click Device CFG

3. Click to select the device from the device tree on the left

4. Click the Event tab

5. Click the Intelligent to open IVS Rule Setup

6. In the pop up menu that appears, first select the Channel No. you wish to configure then click OK

7. On the Smart Plan page, if an existing rule is already setup (highlighted) click it once to de-select

Then click to select the Face Detect icon then click Next

8.Click the checkbox to Enable the rule. To draw the detection zone for Face Detection click 'Re-draw'

9. Left click inside the video frame to draw the detection zone.

Once finished Right click to complete the zone

10. To set a schedule for the IVS Face Detect Rule click the Config button

11. Use the menu to configure a schedule for the IVS rule. By default it will be set to 24/7. Click Save once the schedule has been set.

12. Click Save to finish creating the IVS Face Detect rule