SmartPSS/Menu/Device CFG

SmartPSS Menu-Device Config

Description

The Device Config menu is used to change the settings on IP cameras and NVR's. Follow the instructions below to learn about device configuration through SmartPSS.

Prerequisites

• SmartPSS Installed on computer
• Connected device such as an IP camera or NVR
• Device added onto SmartPSS successfully

Step by Step Instructions

1. Launch SmartPSS and on the home page click DEVICE CFG.

2. On the left column click your designated device to configure.

3. Follow Each section below to access the specific Setting:

General

Network

• TCP/IP: Enter this section to configure the systems IPV4 and IPV6 network settings, you can also enable or disable DHCP here.

• Connect: Enter this section to configure the Max connections and

• PPPoE:'

• DDNS

• IP Filter

• SMTP

• FTP

• Multicast

• Alarm Centre

Remote Devices

Encode

• Audio/Video

Image

PTZ Control

Event

Video Detect

Alarm

Abnormality